Chaintech VNF3-250 NF3-250 Mainboard Review (3)
Gortok 8 May 2004

The only "fault" I've found on the Chaintech's VNF was the lack of ability to change the CPU multiplier. I ran software to change the multiplier in WinXP. Since this is a Windows only solution, there's no way to boot at the multi you like. I'm hoping (not holding breath, though) that Chaintech will provide yet another BIOS update that will remedy this oversight.

So, in keeping with the benching...change multi to 9 and see what happens...

Obviously we're taking a huge hit here...but we can't raise FSB once in Windows after having set multi...

Next >>>

(C) Copyright 1998-2009 OCWorkbench.com